Ucs

[section8]

So dropped off my Evo there around 10ish this morning for an Exedy Twin clutch, clutch fork stop, OEM TOB, SS clutch line to be installed. He calls me around 5ish and tells me it's about complete. Luckily, he ran into no snags and everything went smooth (minus the downpipe gasket, thanks for replacing that:)). When we came by to pick up the ride, either it was so freezing out I didn't notice or that in fact it really did not have any of the usual twin clutch "shatter". Shifting on the way home felt smooth. His prices were very reasonable and with such short notice I'm pleased. He showed me my stock clutch and explained what the burrs meant and how to determine the life of the clutch which was nice. Now to get this break in over with and I'll update. Thanks again Greg, and good luck on that project:)

[ROOKHOE]

Congrats on the new clutch. The Exedy Twin is definately my next clutch.

[LittleRedWagon]

Congrats. That's a nice clutch.

[boost>women]

edit-im slow.

[oneonlywgs]

good stuff. greg is on a roll.

[Rogue]

Good stuff! I am sure Greg is going to have lots of fun doing my clutch swap on my X.

He hooked my up with an install of Coilovers and Roll Center Adjusters a few weeks back.. Now I am riding easy.

[2bwhoIam]

:thumbsup:

Thanks for the kind words all!

Mmmm clutch job goodness on a X. Can't wait for that one!

[Rogue]

trust me I can wait...

[TonyG]

I'll never forget the first launch with my Exedy twin disk. It felt like my Evo gained 50whp. Good luck with it.

[Rogue]

hmm Swaybars sitting in my room.. front and rear.. haha front!

[2bwhoIam]

Fuck me and the front. We'll do that one when we do the clutch! LOL

[Rogue]

hahha...